Difference between revisions of "Bbbmini"
(→ground control station) |
|||
| (12 intermediate revisions by the same user not shown) | |||
| Line 2: | Line 2: | ||
* https://github.com/mirkix/BBBMINI | * https://github.com/mirkix/BBBMINI | ||
* http://diydrones.com/group/bbbmini/forum/topics/tested-hardware-for-bbbmini | * http://diydrones.com/group/bbbmini/forum/topics/tested-hardware-for-bbbmini | ||
| + | * wifi (is a pain) | ||
| + | ** connmanctl | ||
| + | * booting | ||
| + | ** takes long 3 minutes :-( | ||
== rc AND telemetry == | == rc AND telemetry == | ||
| − | * http://www.itluxembourg.lu/site/ | + | * http://www.itluxembourg.lu/site/ultimate-lrs/ |
| + | |||
| + | <pre> | ||
| + | start ArduPilot | ||
| + | para serial port | ||
| + | -A SERIAL0 micro USB port | ||
| + | -B SERIAL3 GPS | ||
| + | -C SERIAL1 Telem1 | ||
| + | -D SERIAL2 Telem2 | ||
| + | -E SERIAL4 | ||
| + | -F SERIAL5 | ||
| + | </pre> | ||
| + | |||
| + | |||
| + | == gps == | ||
| + | * http://navspark.mybigcommerce.com/freebie/ | ||
| + | * Internal GPS/BDS active antenna for use with NavSpark or NavSpark-GL. 25cm cable, U.FL connector | ||
== rules & regulations == | == rules & regulations == | ||
| Line 20: | Line 40: | ||
== receiver == | == receiver == | ||
| − | * https://www.frsky-rc.com/product/d4r-ii/ | + | * ( https://www.frsky-rc.com/product/d4r-ii/ ) |
| + | * OrangeRX 100mW: http://www.itluxembourg.lu/site/ultimate-lrs-wiring-diagram/ | ||
| + | |||
| + | == transmitter == | ||
| + | * OrangeRX 1W | ||
| + | |||
| + | == remote == | ||
| + | * 9XR | ||
| + | * Mixer | ||
| + | ** CH1 Roll | ||
| + | ** CH2 Pitch | ||
| + | ** CH3 Throttle | ||
| + | ** CH4 Yaw | ||
| + | ** CH5 FlightMode | ||
| + | ** CH6 | ||
| + | ** CH7 | ||
| + | ** CH8 Land | ||
| + | ** CH9 ArmDisarm | ||
| + | |||
| + | |||
| + | == ground control station == | ||
| + | * APM Planner | ||
| + | * Mission Planner | ||
| + | * settings | ||
| + | ** FS_BATT_ENABLE = Land | ||
| + | |||
| + | == start/stop == | ||
| + | * /home/debian/arducopter -C /dev/ttyO4 -D udp:192.168.1.241:14550 -B /dev/ttyO5 | ||
| + | * ps aux | grep arducopter | ||
| + | * kill [xxxx] | ||
[[category:Projekte]] | [[category:Projekte]] | ||
Latest revision as of 17:51, 8 November 2017
Contents
BeagleBone Black / Green (BBB / BBG) Linux ArduPilot DIY Cape
- https://github.com/mirkix/BBBMINI
- http://diydrones.com/group/bbbmini/forum/topics/tested-hardware-for-bbbmini
- wifi (is a pain)
- connmanctl
- booting
- takes long 3 minutes :-(
rc AND telemetry
start ArduPilot para serial port -A SERIAL0 micro USB port -B SERIAL3 GPS -C SERIAL1 Telem1 -D SERIAL2 Telem2 -E SERIAL4 -F SERIAL5
gps
- http://navspark.mybigcommerce.com/freebie/
- Internal GPS/BDS active antenna for use with NavSpark or NavSpark-GL. 25cm cable, U.FL connector
rules & regulations
log files
- var/APM/logs
ESCs
PDB
receiver
- ( https://www.frsky-rc.com/product/d4r-ii/ )
- OrangeRX 100mW: http://www.itluxembourg.lu/site/ultimate-lrs-wiring-diagram/
transmitter
- OrangeRX 1W
remote
- 9XR
- Mixer
- CH1 Roll
- CH2 Pitch
- CH3 Throttle
- CH4 Yaw
- CH5 FlightMode
- CH6
- CH7
- CH8 Land
- CH9 ArmDisarm
ground control station
- APM Planner
- Mission Planner
- settings
- FS_BATT_ENABLE = Land
start/stop
- /home/debian/arducopter -C /dev/ttyO4 -D udp:192.168.1.241:14550 -B /dev/ttyO5
- ps aux | grep arducopter
- kill [xxxx]
