MIA electric

sandbox

CAN sniffing

• parts
  • Arduino UNO R3 (or CH340 clone EUR 6,49)
  • MCP2515 / TJA1050 shield (8MHz EUR 4,79)
  • https://github.com/latonita/arduino-canbus-monitor (MCP_8MHz, CAN_500KBPS)
  • CANcool https://github.com/MHS-Elektronik/CANcool

DC charging

CCS

• prerequisites
  • explore V2G protocol
    • http://openv2g.sourceforge.net
    • http://openv2g.org
    • https://www.v2g-clarity.com/en/risev2g
  • discover BMS <> Charger CANbus conversation
    • BMS/Battery e4v.eu
    • onboard charger ies-synergy.com
  • develop BMS <> PCL communication

• parts
  • CCS-socket e.g. Phoenix Contact ~EUR 800,-
  • input voltage monitor
  • power contactor (+125A disconnecting device) Tyco ~EUR 150,-
  • current monitor
  • V2G in-vehicle-charge-controller e.g. EVAcharge SE ~EUR 750,-
    • ARM microcontroller
    • Linux OS
    • fully programmable
    • PWM duty cycle detection (CP low level communication)
    • switchable resistors (CP low level communication)
    • HomePlug Green PHY integration (PLC high level communication)
    • Proximity pilot signal input (PP)
    • lock-motor output
    • lock-motor end switch input
    • lock-motor fault pin
    • CAN transceiver (BMS communication)
    • 6 GPIOs (current-monitoring?, voltage-monitoring?, temprature-monitoring?, power contactor-driver?, (contactor-monitoring?))

• docs
  • http://tesla.o.auroraobjects.eu/Design_Guide_Combined_Charging_System_V3_1_1.pdf