Difference between revisions of "RPiAIS"
(→install) |
(→rtl-sdr use apt-get insall rtl-sdr instead) |
||
| Line 32: | Line 32: | ||
== install == | == install == | ||
| − | === <strike>rtl-sdr</strike> use <code>apt-get | + | === <strike>rtl-sdr</strike> use <code>apt-get install rtl-sdr</code> instead === |
* connect via ssh or scp as pi | * connect via ssh or scp as pi | ||
<pre> | <pre> | ||
Revision as of 08:41, 14 October 2018
Contents
stretch
- get http://www.aishub.net/rpiais
- enable SSH permanently
- check http://192.168.1.100:8080
- set configuration
- input UDP Server
- host 127.0.0.1
- port 5001
- start dispatcher
setup
- connect via ssh or scp as pi
sudo apt-get update sudo apt-get upgrade sudo su mc
- enable root login over SSH
- add to /etc/ssh/sshd_config
PermitRootLogin yes
- restart service
sudo /etc/init.d/ssh restart
- set root password
sudo passwd root
- add to /etc/ssh/sshd_config
- set up static IP at /etc/dhcpcd.conf
interface eth0 static ip_address=192.168.1.110/24 static routers=192.168.1.1 static domain_name_servers=192.168.1.1
- reboot
install
rtl-sdr use apt-get install rtl-sdr instead
- connect via ssh or scp as pi
sudo su - apt-get update apt-get install git git clone git://git.osmocom.org/rtl-sdr.git apt-get install libusb-dev libusb-1.0 libtool cmake apt-get install build-essential cd rtl-sdr/ mkdir build cd build cmake ../ make make install ldconfig cd .. cp rtl-sdr.rules /etc/udev/rules.d/
- Blacklist the kernel module dvb_usb_rtl28xxu by adding the line
blacklist dvb_usb_rtl28xxuto /etc/modprobe.d/blacklist-dvb_usb_rtl28xxu.conf - reboot
- Test the installation:
rtl_test -t- output:
Found 1 device(s): 0: Realtek, RTL2838UHIDIR, SN: 00000001 Using device 0: Terratec Cinergy T Stick RC (Rev.3) Found Elonics E4000 tuner Supported gain values (14): -1.0 1.5 4.0 6.5 9.0 11.5 14.0 16.5 19.0 21.5 24.0 29.0 34.0 42.0 Sampling at 2048000 S/s. Benchmarking E4000 PLL... [E4K] PLL not locked for 51000000 Hz! [E4K] PLL not locked for 2187000000 Hz! [E4K] PLL not locked for 1094000000 Hz! [E4K] PLL not locked for 1243000000 Hz! E4K range: 52 to 2186 MHz E4K L-band gap: 1094 to 1243 MHz
rtl-ais
apt-get update apt-get install rtl-sdr librtlsdr-dev libusb-1.0-0-dev git clone https://github.com/dgiardini/rtl-ais cd rtl-ais cp rtl_ais /usr/local/bin/
- add /etc/systemd/system/ais.service
[Unit] Description=AIS After=syslog.target network-online.target [Service] Type=simple User=root ExecStart=/usr/local/bin/rtl_ais -p 28 -P 5001 Restart=on-failure RestartSec=10 KillMode=process [Install] WantedBy=multi-user.target
- systemctl daemon-reload
- systemctl enable ais
- systemctl start ais
